Inspecting Your ATV

An easy way to remember the items to inspect is the phrase “START-GO.”

Steering and Drive System

• Drive chain: Check your owner’s manual for proper adjustment. Inspect and lubricate the chain regularly.
• Drive shaft: Check for leaks, and consult your manual for proper lubricant levels.
• Handlebars and footrests: Shake to make sure they’re secure.

Throttle and Brakes

• Throttle: Make sure it moves smoothly and snaps closed.
• Ignition switch: Check for wear.
• Engine stop switch: Test operation.
• Brakes: Test to make sure controls operate smoothly.
• Foot shifter: Make sure it’s attached firmly and positioned for safe operation.

Activate Lights

• Headlights and taillights: Turn them on.
• Brake lights: Press the brake, and have your riding partner make sure the brake lights illuminate.

Registration

• Make sure your registration or trail pass decals are attached.
• Confirm that the dates are still valid.

Tires, Wheels, and Suspension

• Tires:
  • Always use a low-pressure gauge to check tire pressure.
  • Make sure pressure is equal on both sides.
  • Check for damage that could cause air leaks.
• Axle nuts: Make sure they’re tight and secured by cotter pins.
• Bearings: Try to rock the wheel on its axle to check for wear.
• Major fasteners: Periodically tighten all major fasteners with hand tools.

Gasoline

• Gasoline: Make sure the tank is full.
• Leaks: Check for fuel leaks.

Oil

• Oil: Check while the engine is off.
• Leaks: Check for oil leaks.

Additional Items

In addition to checking the items listed in START-GO, your pre-ride inspection should include the following.

• Spark arrestor/muffler: Make sure it’s attached firmly and working properly.
• Air filter: Make sure it’s clean, undamaged, and unblocked.
• Spark plugs: Replace if necessary.